Additional Description:
The Barrier Post is the most popular traditional fixed bollardwe stock our Irish warehouse.

The Barrier Post fixed bollard is a no frills traditional bollard that will restrict vehicle access. The Barrier Post fixed bollard is bolted to the ground using our chemical fixings and can be installed by anyone in minutes. The Barrier Post fixed bollard is commonly seen in car parks and retail parks where there is a lot of traffic and space is limited. The Barrier Post fixed bollard will prevent drivers from parking in restricted areas and it will also prevent them blocking off paths used by pedestrians. Our Barrier Post fixed bollard can be moved should needs be by simply removing the fixings.

Ideal for walkways, industrial sites, traffic dictation(one way systems), boundary posts and access restriction.

Height 1000mm, 70 mm sided post.

Additional Description:
Black speed ramp middle section manufactured from recycled pvc rubber, 50mm high x 500mm length. Interlocks with yellow middle sections and also end sections. 8 kg in weight and are fixed to the floor with fixing bolts (4 bolts needed per section).

Additional Description:
Curvature 60 (1M) Impact Protection Foam

Additional Description:
The Easy Rider rubber speed bump reduces vehicle speeds to approx. 5 mph (approx.), making parking lots safer for pedestrians and motorists. Constructed from 100% recycled tyres, GNR speed bumps are preformed to ensure a smooth, safe ride. The channeled bottom helps facilitate drainage as well as cover cabling or piping. The Easy Rider speed ramps flexible design conforms to the contour of virtually any road surface. End caps can also be purchased to protect the speed bump ends and vehicles. The Easy Rider speed ramp can be installed for temporary or permanent use, and is covered by a 3 year warranty on the speed ramp and a 1 year warranty on the yellow tape (under normal usage).

(L) 180 cm x (W) 30,5 cm x (H) 5,7 cm - 23,1 kg.

Additional Description:
Circular 40/40/8 (1M) Impact Protection Foam

1000mm sections of push-on fitting impact protection foam - ideal for edge protection

Additional Description:
Trapeze 40 / 40 (1M) Impact Protection Foam

Surface protectant.
Self-adhesive fitting.
Impact protection foam
1000mm section

Additional Description:
Rectangle 200 / 20 (500mm) Pre-drilled Impact Protection Foam

500mm sections of pre-drilled impact protection foam - ideal for wall-mounting

Additional Description:
Right Angle 30/30 (1M) Impact Protection Foam Black / Yellow

Additional Description:
Male End-Cap to combine with Safety Rider main-body.

Additional Description:
The Safety Rider offers a compromise in that it will slow vehicles yet not be so severe as to cause a build up of traffic. It is made by the same manufacturer as the Easy Rider, GNR technologies. Due to its construction from recycled rubber it gives a smooth and uniform surface which is not possible with asphalt.
Safety Rider speed hump offers a 3 year warranty.

The Safety Rider section measures 500 x 900 x 50mm (L x W x H). You can combine the sections along with the end-caps to cover whatever distance you choose.

Additional Description:
Trapeze 40/80/8 (1M) Impact Protection Foam

1000mm section
push-on fitting impact protection foam

Additional Description:
Yellow speed ramp end section manufactured from recycled pvc rubber, 50mm high x 250mm length. Interlocks with black middle section, weighs 3 kg and is fixed to the floor with fixing bolts (2 bolts needed per end section).